Relax, We Are INSTALLATION Experts two vents professionally installed only $299!
Just Me Venting provides expert professional installation for only $299 for the complete two vent package! The job will be completed and all you had to do is open the garage door and give us access to the inside of the garage. We do ALL the rest! It can not be any easier than that! Come on, are you waiting for?
As Appreciation for Your Service We Offer a 10% Discount to Active and Retired Military, Law Enforcement Fire and EMS Personnel*
*Please notify us at the time of order. 10% discount may be used if no other discounts are applied.
Option - 2 Order Your WindeeVents From Us And Install Them Yourself for $199.
Our very affordable installation rates make it hard to consider installing the Garage Vents yourself, however, you can purchase your vents, from us, and do the installation yourself, if you wish. Intermediate craftsman skills are highly recommended, in addition to a working knowledge of sheet metal cutting. With the proper tools and intermediate skill level the two vents can be installed in as little as 60 minutes. The system consists of two louvered vents, mounting hardware, sealant tape and a back plate which doubles as a template for cutting the opening in the garage door. The tools you'll need are:
Variable Power Drill
1/4″ Drill Bit
Metal Cutting Tool (dremel shears, snips)
Extra Cutting Blades
Wrench (10mm socket)
Larger Philips Screwdriver
Level
Pencil
Protective Eye Wear
Gloves
This is what you'll need to do: Always use proper safety gear. Do not operate the garage door at any time during installation. Note: It recommended that vents be installed opposite of each other, ie, the top left side and bottom right side if there are no other adequate air sources within the garage. Please note measurements before installation: 17 ½ x 12 ¼ outside external 15 ¼ x 9 ¾ hole size | 2 ½ deep.
Select the location to install vents.
Position and level template / back plate at the install location. Note: It is important to ensure back plate is level before cutting.
Mark bolt locations and trace the inside of the leveled template.
Drill holes for bolts.
Cut along the traced template line. Note: If using snips, drill a hole on traced line for a starting location.
Apply sealant tape to back of vent. Note: Remove adhesion cover on both sides before inserting bolts. Making an incision through the tape after applying to the back of the vent will help bolts punch through tape.
Insert all bolts through holes on the vent.
Insert vent and all bolts through garage door and press unit firmly to allow tape to bond with door. Note: For maximum adhesion, the surface must be clean.
From inside the garage, line up back plate through bolts, attach nuts and tighten to secure vent.
Enjoy your new Windee Vent System.
The Usual Legal Disclaimer WindeeVents must be properly installed in order to function as designed and it is recommended that a certified installer perform the installation. The team at WindeeVent has made every effort to provide customers with a detailed set of installation instructions, however, WindeeVent is not responsible for improper installation or for any issue that is related to the installation of this product. Installation is at your own risk and WindeeVent does not control nor warrant the item or the cost of installation.
